Check these out too...

Monday, July 23, 2012

Changing the bobbin in midstream

For the last month all I've been doing in the studio is quilting.  Can't count how many spools of thread I've gone through and how many bobbins I've wound, but I can tell you with absolute certainty that it's a drag to run out of bobbin thread somewhere in the center of the quilt.  But I have figured out a routine that minimizes the angst.

Here's how I do it.

When you realize the bobbin has run out, lift the presser foot and pull the quilt toward you till you find the last complete stitch.  Pull the bobbin thread to the top of the quilt.  It's probably only about a half-inch long, not long enough to bury with certainty that it will stay buried.  So pull out a few stitches back, always pulling the bobbin thread to the top, until it's at least an inch long.

Put a new bobbin in.  Now grab the loop of top thread and stick your finger into the loop so the takeup mechanism won't pull it taut.

Position the needle exactly at the last stitch.  Rotate the wheel manually one turn so the needle goes down and grabs the end of the new bobbin thread and comes back up again.  Pull on the top thread (still wrapped around your finger) until the bobbin thread peeks up above the quilt surface.

Snag the loop with a needle, tweezer, seam ripper or other tool and pull until the end of the thread comes up.  

Pull the thread end over to the side, along with the thread end from the old bobbin and hold them both firmly with your finger so they won't escape.  With your other hand, grab the top thread on top of the sewing machine, somewhere between the spool and the tension plates, and pull it backwards so the thread is taut between the quilt and the needle.

Lower the presser foot so the needle is exactly in place to continue the stitch line.  Holding the thread ends taut with your finger, start stitching again.

The quilting line will look perfect, because the top thread is uninterrupted.  Later, go back and sink the thread ends.  If you don't know how to sink thread ends, check out this tutorial.

8 comments:

  1. VERY good. Makes alot of sense.
    Hope all your hard work is rewarded.
    Sandy in the UK

    ReplyDelete
  2. Thanks, Kathy. This looks like a perfect solution to a problem that has often vexed me. Now I have to get some needle threaders for burying those ends, too.

    ReplyDelete
  3. Neat trick Kathy. I even got to try it out while sewing a facing on a quilt. Thanks!

    ReplyDelete
  4. Thank you, Kathy. I really enjoy your blog and appreciate your willingness to share your process. Looking at these close-up photographs makes me wonder about how you decide on a quilting pattern or strategy. I'd love to know more if you're willing to address that topic sometime.

    ReplyDelete
  5. Good question, Sharon! I'll think about it (while I quilt) and write about it soon.

    ReplyDelete
  6. THAT is CLEVER. It's a long time since I machine quilted anything but this is a neat trick to know. Thank you.

    ReplyDelete